McCulloch MRT850 Manual del operador

Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine. The use of any gasoline exceeding 10% ethanol (E10) will void the

10OPERATIONTILLING HINTS (See Fig. 13)CAUTION: Until you are accustomed to handling your tiller, start actual field use with throttle in slow positio

11• Do not lean on handle. This takes weight off the wheels and reduces traction. To get through a really tough section of sod or hard ground, appl

12MAINTENANCEGENERAL RECOMMENDATIONSThe warranty on this tiller does not cover items that have been subjected to operator abuse or negligence. To re

13MAINTENANCEFig. 17Disconnect spark plug wire before performing any maintenance (except car bu re tor adjustment) to prevent accidental start ing of

14MAINTENANCEMUFFLERDo not operate tiller without muffler. Do not tamper with exhaust system. Damaged mufflers or spark arresters could create a fire

15SERVICE AND ADJUSTMENTSCAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.TILLERTO ADJ

16SERVICE AND ADJUSTMENTSCABLE CLIPSCREWDRIVECONTROLCABLEEXTENSIONSPRINGENGINEPULLEYIDLERPULLEYTRANS MIS SION PULLEYLESS TEN SION5/8"MORETEN SIO

17SERVICE AND ADJUSTMENTStine_3Fig. 26• To maintain the superb tilling performance of this ma chine the tines should be checked for sharpness, wear,

18SERVICE AND ADJUSTMENTSFig. 28engine_art_78THROTTLE CONTROLCLAMP SCREWCASING AND WIREENGINETO ADJUST THROTTLE CONTROL CABLE (See Fig. 28)The thrott

19STORAGEENGINE OILDrain oil (with engine warm) and replace with clean oil. (See “ENGINE” in the Maintenance section of this man ual).CYLINDER(S)• R

2• Never operate the tiller without proper guards, plates, or other safety protective devices in place.• Keep children and pets away.• Do not ove

20TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operat

21SERVICE NOTES

22SERVICE NOTES

23SERVICE NOTES

www.mcculloch.biz02.08.12 DHPrinted in U.S.A.

3CONGRATULATIONS on your purchase of a new tiller. It has been designed, en gi neered and manu fac tured to give you the best pos sible de penda bil i

4TOOLS REQUIRED FOR ASSEMBLYA socket wrench set will make assembly easier. Standard wrench sizes are listed.(1) Utility knife(1) Tire pressure gauge(

5ASSEMBLY• Grasp handle assembly. Hold in “up” position. Be sure handle lock remains in gearcase notch. Slide handle assembly into position.Fig. 4

6ASSEMBLYREMOVE TILLER FROM CRATE• Make sure shift lever indicator is in “N” position (See Fig. 6)• Tilt tiller forward by lifting handle. Separate

7KNOW YOUR TILLERREAD THIS MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER.Compare the illustrations with your tiller to familiarize yourself wit

8OPERATION00155HOW TO USE YOUR TILLERKnow how to operate all controls before adding fuel and oil or attempting to start engine.STOPPING (See Fig. 8TIN

9OPERATIONTO TRANSPORTCAUTION: Before lifting or trans port ing, allow tiller engine and muffler to cool. Disconnect spark plug wire. Drain gasolin